08
2025
-
09
Can faux mink clothing be ironed?
Temperature: Set the iron to the “polyester” setting (≤ 120°C); above 130°C, micro-polyester will begin to melt and leave permanent shiny spots.
-
Temperature: Set the iron to the “Polyester” setting (≤ 120°C); above 130°C, micro-polyester will begin to melt and leave permanent shiny spots.
-
Ironing cloth: a clean cotton T-shirt or a 0.2-mm-thick fabric interlining; it may be slightly damp, but must never be wet, to prevent steam from penetrating the pile.
-
Sequence: Slide on the reverse side for 5 seconds → Cool for 10 seconds → On the front side, quickly “press–slide–lift” at each spot, ensuring no single spot is pressed for more than 2 seconds to avoid damaging the pile.
-
Prohibited Areas: No steam bursts; no vertical steam jets; no fabric-finishing sprays (5% alcohol will strip the silicone finish, resulting in a rougher hand feel).
-
Post-care: Hang immediately on a wide-shoulder hanger and allow to cool naturally; for added volume, blow cold air from 20 centimeters away for 30 seconds—the pile will regain its “mink-like” appearance.
-
By following these five steps, you can safely remove wrinkles while preserving at least 95% of the original appearance.
Related information
Address
5th Floor, Hangzhou Tangchi Plastic Film Technology, No. 6 Yuanliu Road, Shanbei Village, Guali Town, Xiaoshan District, Hangzhou, Zhejiang Province, China